This program is not for therapeutic use on the patient but is for the testing of the function of the ENERGYSCAN QXCI device. Make sure that you follow all installation instructions for each screen, from demographics to test screen. Make sure that you have batteries in the lower compartment or that you have a charger hooked up. The green light on the front of the box should be on. The harness should be properly hooked up for the entire test. Check the boxes as to the color of your box, and if a patient is hooked up properly. Make sure that your computer is surge protected, and that the cable to the computer port is correct. The switch on the front of your system needs to be switched to function. If any of the following is wrong the system can not measure the functions properly. After running the program the computer should tell you that the software is operative the patient link is correct and functioning, The subspace link is established, the null field is active, and the device link is established.